The 3000 Miles Oil Change Interval Doesn’t Address Oil Quality
When people say to me they change their oil at 3000 so not to take any chances that dirt could be causing damage or the oil could be getting “bad”, I say to them, why not change every 50 miles then?? I’m sure the oil is still good but as you said, why take a chance?
Let’s look at the top reasons for engine failure which relate to the oil.
#1 is lack of lubrication. Nothing to do with dirt but a poor quality non-synthetic even low quality synthetic made from Group III base stocks (There are over 80 different quality levels for a Group III oil thus lower prices – this does not fit the scientific definition of synthetic) can and will leave deposits OR lose viscosity early on both causing lack of lubrication.
#2 – Overheating – Often the damage done after a engine overheats is caused by the heat being too intense for the oil to hold its properties. An AMSOIL product would have prevented this especially in air cooled (V-Twin bikes or marine) and in the new trend of turbocharged engines. The coming LSPI issue will demand the oil be at least a 100% synthetic quality. It’s designed for temperatures beyond these issues. Our Signature, XL and OE series oils are the solution to this issue. More on this in future additions but AMSOIL has now been tested to exceed the Dexos Gen 2 test 100%. (The requirements to pass allows 5 LSPI events which is too many. We pass with ZERO events (pre-ignition)!!
So changing oil every day will not prevent the above. Any overheating event or the list of reasons which cause a lack of lubrication cannot be addressed by the 3000 mile oil change. Only by the quality of the oil. AMSOIL also adds performance and for the difference in price per quart is less than the cost of a cup of today’s coffee so the solution for protecting your investment is here!! And has been for 45 years.
Quality Oil Filtration is a Must but still only part of the issue
I couldn’t find the study as I was writing this but Federal Mogul published research that “dirt” in oil was actually a minor part of failure while things relating to lubricant quality were. Acids or loss of TBN was a much more severe issue. Corrosion and storage was a far greater contributor to reduction in engine efficiency and ultimately failure.
Mild quality oil filters solve the dirt issue for up to 10,000 miles but you still need an oil which can fight contaminants caused by fuel or advanced wear over the years (such as starting with a used vehicle which you don’t know the history of). AMSOIL addresses the contaminants with their advanced additive packages and are willing to cover that with a guarantee.
How do you know?
Note while that AMSOIL does back their oil for longer intervals, this is clearly stated for engines which are in normal operating condition and have not been modified. For modified engines, neglected ones or those with a good number of miles over 100,000 they do list severe service categories or one can always get our KIT-02 oil analysis kit and go from there.
Just use better oil and find out what you are missing!
AMSOIL use will tilt the scales of a nations fleet replacement statistics. Imagine that. Just from changing brands of oil. Signature Series 100% Synthetic Motor Oils is your best bet in preventing these problems but the roll out starts now for upgraded OE and XL oil lines designed to combat pre-ignition issues.
The 3000 mile oil change interval excuse is much like arguing one brand of cigarettes is more healthy than another.
Use AMSOIL and unlock the full potential of your drive train!! Find out what others already know – AMSOIL is all about performance!
Ches Cain – AMSOIL Direct Jobber
