Semi-Fluid 00 Synthetic EP Grease Formulated with high-viscosity ISO-460 synthetic base oils and a sophisticated additive package, providing unparalleled protection against wear. Ideal for leaky gear boxes in industrial and fleet applications, centralized lubrication systems and for use in applications that are difficult to service.
Formulated to Lubricate and Protect Agricultural and Commercial Equipment
AMSOIL Semi-Fluid Synthetic EP Grease is formulated with high-viscosity ISO 460 synthetic base oils and a sophisticated additive package, providing an effective protection system that helps reduce wear and prevent damage. Its advanced extreme-pressure additives provide superior protection and performance in shock-loading applications that can rupture the oil film of conventional greases and lead to damaging metal-to-metal contact. AMSOIL Semi-Fluid Synthetic EP Grease resists water and provides superior protection against corrosion and oxidation, which can eat away and destroy critical components and lead to equipment failure.
AMSOIL Semi-Fluid Synthetic EP Grease helps solve problems associated with leaky gearboxes and difficult-to-service applications in industrial and fleet markets. It is primarily used in grease-filled cases where conventional semi-fluid greases do not provide adequate lubricant life or protection. AMSOIL Semi-Fluid Synthetic EP Grease is the primary grease recommendation for truck wheel hubs as outlined in RP 631B, issued by The Technical and Maintenance Council of the American Trucking Association.
AMSOIL Semi-Fluid Synthetic EP Grease is recommended for, but not limited to, the following agricultural applications:
AMSOIL Semi-Fluid Synthetic EP Grease may be appropriate for the following commercial applications:
|Thickener Type||Lithium Complex|
|Penetration (ASTM D-217) Worked 60 Strokes||403|
|Dropping point, °C (°F) (ASTM D2265)||282 [>540]|
|Base Oil Viscosity, cSt @ 40˚C (ASTM D445)||ISO 460|
|Timken OK Load, lbs. (ASTM D2509)||60|
|Viscosity at 40°C in cSt||460|
|Viscosity at 100°C in cSt||46|
|Rust Prevention ASTM D-1743||PASS|
|Timken OK Load ASTM D-2509||50|
|Four Ball EP Weld Load KG||200|
|Typical Service Range °C [°F]||-29 [-20] to 190 |
AMSOIL Semi-Fluid Synthetic EP Grease is compatible with many other types of greases. However, it is recommended that when changing greases, the equipment be cleaned of the old grease when possible or flushed with a liberal amount of Semi-Fluid Synthetic EP Grease while the mechanism is in operation. Closely monitor the system for any inconsistencies. Grease compatibility questions should be referred to your AMSOIL representative or AMSOIL INC.
GREASE STORAGE AND HANDLING
Grease should always be stored in a cool, dry area with temperatures above freezing but below 80°F. Store grease in the original container in an upright position and avoid direct sunlight. During long periods of storage, grease may exhibit a slight change in appearance. For further technical questions about the storage and handling of grease, contact AMSOIL Technical Services.
AMSOIL PRODUCT AVAILABILITY
AMSOIL Semi-Fluid Synthetic EP Grease is available in 35-lb. pails and 120-lb. kegs and 400-lb. drums are available by special order.
HEALTH & SAFETY
This product is not expected to cause health concerns when used for the intended application and according to the recommendations in the Safety Data Sheet (SDS). An SDS is available via the Internet at www.amsoil.com or upon request at (715) 392-7101. Keep Out of Reach of Children.
For warranty information, visit www.amsoil.com/warranty.aspx.